A gas dryer is not an electric dryer with a different plug. It needs a gas supply the maker specifies, a 120-volt receptacle for the motor and controls, and a vent path that actually leaves the building. Miss one of those three and the install is incomplete.

If the laundry closet has no exterior duct, that is a ventless dryer conversation, not a gas hookup. Stay here when the house already has, or will have, a gas dryer connection.

Confirm fuel, power, and the vent before delivery

Photograph the existing hookups before the new machine arrives.

  • Gas: shutoff location, connector type, and whether a cap sits on an unused stub. Do not open the valve to “test.”
  • Power: a 120-volt receptacle, not a 240-volt dryer outlet left from an electric unit
  • Vent: transition hose, rigid run, and the exterior hood

Swapping an electric dryer for gas is a different job than replacing gas with gas. A 240-volt outlet does not feed a gas dryer’s motor. A missing shutoff or a connector that does not match the new unit is not a homeowner conversion from this page. Gas-line work is separate from BHGS appliance-dealer registration. This brand does not hold a CSLB number.

If you see, hear, or smell signs of a gas leak, leave immediately and call 911 or SDG&E at 1-800-411-7343 from a safe location. Follow SDG&E’s gas-appliance safety guidance. Do not keep installing.

San Diego laundry rooms vary. A Mira Mesa garage often has a short vent and an exposed shutoff. A downtown stacked closet may hide the connector behind the washer. An East County house can have a long rigid run that was never sized for the new blower. The installer needs those photos, not a guess.

No verified countywide permit rule for a like-for-like gas dryer swap appears in the approved sources for this guide. Ask the installer which local authority covers the property, then confirm any permit question with that city or with the County for an unincorporated address.

What the installer should check on site

The independent technician you match with should verify the shutoff, the connector, leak-test the joints they work on, confirm the 120-volt feed, and prove exhaust at the exterior hood. A crushed foil hose behind a tight closet is a common find. So is a roof cap that does not open.

Do not ask this page for a step-by-step gas-flare tutorial. That work belongs to the person who will be responsible for the connection.

If the dryer later runs with no heat, that is a dryer repair visit. If clothes take two cycles after a new install, start with clogged dryer vent symptoms and tell the tech the machine is newly set.

Repair Pro San Diego matches homeowners with insured independent technicians through appliance installation. We do not run gas lines, stock connectors, or set a fee. Ask about the trip charge, whether installation is quoted as a package, and whether you get that quote in writing before they unbox the dryer.

Confirm BHGS registration on the DCA lookup. Registration is status, not a skill grade.

When to call us

If you need a gas dryer installed in a San Diego County home and the fuel, power, and vent notes above are ready, match with a licensed local appliance pro. Call (858) 988-7787 to leave a voicemail requesting a match with a local appliance repair pro. The technician you are matched with inspects the hookups, quotes in writing, and does the work.